Connect laptop bsnl modem through wifi

C Now click on Interface setup and then on the internet. Username : this will be your broadband user id. BSNL internet service provider will provide this at the time of connection. Once you get you get your username, put it on the appropriate field. After putting username and password click on SAVE button.

SSID : Put any name here. This will be your wifi access point name. Pre-shared key : This will be your wifi password. Now click on SAVE button and close the browser. A quick tip, you should change the wifi password of BSNL modem regularly to protect your network. You have now successfully configured your modem. I suggest you upgrade the firmware of this modem immediately after configuration is done. Liked this post? Keep visiting Bpedia. See you soon. A blogger who loves to write about things that add value to the readers.

He is more of a solution provider rather than a typical content writer. You can contact him at admin bpedia. HI bro i was also facing the same issue, i did this steps, but again i choose to reset by pining the reset hole at back of the router. Now the issue which i am facing is my wlan led has stopped blinking or in other word i would say it is off. Hi harshad, have you reconfigured the device after doing the reset?

If not then reconfigure it. And the wlan led is not blinking because you have not activated it. Login to And then put wifi password and save it. Hope this helps your problem. Hi rahul. Please activate the access point by logging into the modem under wireless tab. Wifi led will start blinking then. This means that the Modem has successfully integrated to your LAN system. This will take you to the Modem Configuration page.

Enter username: admin and password: admin when prompted. If it fails to authenticate then check your BSNL manual to get the username and password. This will lead you to a page like this… click to enlarge Delete any PPPoE connection you notice on that page.

Just press the delete Tab after the configuration. This will bring you a wizard to create a new Protocol. Double click on it to acce ss the properties. Now enter the following details in the respective fields.

Hit OK and you are done. Make sure to check it and access its properties and do the necessary things as stated above. Save all the settings and you are done configuring your LAN. Select the first option, i. Now onwards you need to enter this ten digit key to log in to your wireless n.

Hi, u need not 2 use the CD provided by bsnl. U instal the WLAN driver in search 4 wireless network it will detect.. If not u need to enable it Regards, L. Arun Kumar. Wireless settings worked for me like a charm Your reply. Ask a question.